After reading through the following instructions completely, confirm all controls on fireplace
heater are in the OFF position. Plug the fireplace into a 15AMP/120Volt outlet. Once the
fireplace insert has been properly connected to a grounded, electrical outlet, it is ready to operate.
Operating Instructions
The controls are located behind the grill below the front glass and can be accessed by pulling grill
from the top. Pull forward and down.
O/I:
Press this button for main power and flame effect. The indicator light will turn on.
1250W:
For heat function - Press this switch while the O/I switch is in the ON position. The
indicator light will turn on.
Temperature Control:
To adjust the temperature to your individual requirements, turn the
temperature control dial to the right (clock-wise) to increase the desired temperature and to the left
for lower temperature. This temperature control dial can only be used while the O/I switch and
1250W switch are in the ON position.
Note:
When the O/I switch is turned off, the heater functions will stop even though the switches
may be in the ON position.
Maintenance
WARNING:
Disconnect power before attempting any maintenance or cleaning to reduce the
risk of fire or electric shock.
Cleaning
Before cleaning any parts of the fireplace make sure to first turn off the controls and then unplug
the unit from power source.
CAUTION:
Wait until the unit has completely cooled before attempting any cleaning.
Cleaning glass door: Remove dust with clean dry cloth. Remove fingerprints and other marks
from glass door by using a clean damp cloth. Do not use abrasive cleaners or spray liquids on
glass door surfaces.
Metal and metal painted parts should be cleaned with clean damp cloth only. Do not use abrasive
cleaners or spray liquids on this surface.