Stone RP522, Operator'S Manual

Page: 22 / 36

- 22 -
3. OPERATION
RP522 & RP652
3.17 TO START THE ENGINE
Important - To prevent engine damage through oil
deficiency, the engine is provided with a low oil
warning system. If the oil level is too low, the engine
switches off automatically (the engine switch
remains in the ON position).
1. Move fuel tap (3) to “ON”.
2. Move choke lever (2) to “CLOSE”.
3. Adjust engine speed control lever (1) to full
load.
4. Move engine switch (5) to “ON”.
5. Pull starter handle (4) slightly until a
resistance is felt, then pull out sharply.
6. Allow engine to warm up for one to two
minutes.
7. As the engine warms up, gradually move the
choke lever to the “OPEN” position.
Attention - Do not allow starter handle to rebound
against the engine. Guide starter cable back by hand
to the rest position. Do not operate choke lever if
engine is warm or at high outside temperature.
3.18 OPERATION
•
Allow the engine to warm up for one to two
minutes when idling.
•
Adjust the engine speed control lever to full
load position.
Attention - The engine speed should always be well
below or well above the engaging speed of the
centrifugal clutch* since, otherwise, the clutch
linings will wear very quickly or could even be
destroyed.
*ca. 2000 1/min
•
Adjust the direction of travel and speed at
the control lever.
•
Guide and steer the machine at the control
arm.
3.19 TO STOP THE ENGINE
1. Adjust engine speed control lever (1) to idle
position.
2. Turn engine switch (4; E-Start 6) to “OFF”.
3. Move fuel tap (3) to “OFF”.
Important - In an emergency situation, set the engine
switch to the OFF position in order to stop the
engine.
I II
Close
ON
OF
F
ON
2
1
3
4
5
II
I
0
A
B