ASSEMBLY INSTRUCTIONS
Assemble the fountain in the location you intend to use it. Do not move with
water in the fountain.
1. Place the basin on a flat, level surface. Route the pump power cord out
from the cord slot at the bottom of basin.
2. Place the fountain top onto the center of basin making sure to align the
tabs in the wedge plate before lowering it. Turn clockwise to secure the
fountain top to the basin.
3. In the basin pump housing, insert the water supply tube from the
underside of the fountain top into the pump outlet located at the top of the
pump. Place the pump upright within the pump housing. Place the lamp
into the lamp socket of the basin, then attach the cover to the pump
housing. Route the lamp cord out through the fillister of the cover.
4.
Fill the basin with clean water. Do not fill past water line marked on the
inside edge of the basin.
5. Connect the lamp power cord to the transformer and then connect the
power cord and the pump power cord to a properly grounded receptacle
(GFCI). The fountain will function as intended. If the water does not flow
evenly around the sides of fountain top, gently sweep across the water
surface to get an even water-flow effect. Adjust the direction of the lamps
for better lighting effect. Remember to always disconnect from the power
source before adjusting the lamps.
6. If necessary, adjust the flow rate to the desired level. Remember to
always disconnect from the power source before adjusting the pump.
WARNINGS:
1. The fountain is not a toy. Always keep the fountain out of reach of children and pets.
2. To eliminate water damage to floors and/or surrounding fountain areas, check for leaks and excessive splashing after initial
installation and on a regular basis.
3. Place the fountain in a location that will not be damaged should the area come in contact with liquids.
4. If the fountain is not in use for an extended period of time, disconnect the power and empty all the water from the fountain.
5. The fountain should not be operated in temperatures below 5°C / 41°F to prevent frost damage. If the fountain is stored outdoors in
freezing temperature, disconnect the power, empty all the water from the fountain and make sure it is completely dry. Cover the
fountain to prevent water from collecting in it.
6. The light bulbs should be operated only when completely submerged in water. Dry operation of the light bulbs may result in damage
of lens. Check the water level regularly, to ensure the light bulbs are completely submerged during operation.
7. Operate fountain with fresh water only. Avoid heavily chlorinated water and water with high pH levels.
8. Do not leave the fountain running unsupervised for extended periods of time.
Note:
Each fountain product may have minor variations in texture, finish and appearance. Some products and finishes are intentionally
weathered and worn in appearance to enhance the aesthetic beauty of the finished product and make each fountain truly unique.