ASSEMBLY INSTRUCTIONS
Estimated assembly time: Approximately 30 minutes
Assemble the fountain in the location you intend to use it. Do not move with water in the fountain.
1.
Place the fountain base on a flat, level surface for the assembly
and location of the fountain. Place the pump into the pump
housing in base. Lead the pump power cord and pump output
cords up inside the back of the base and out of the top center
hole at back of the base. Place the attached submersible lamp
into the light socket at the bottom of the base.
2.
While facing the fountain top, align the three mounting holes on
the iron rack with the corresponding holes on the fountain top.
The front of the iron rack should be flush with the front of the
fountain top. Attach the iron rack to the fountain top using two
large bolts on the left and right sides of the iron rack and the top
screw at the top of the iron rack.
3.
Position the partially assembled fountain top onto the basin
making sure the water supply tube, extending from the
underside of the fountain top is inserted into the center hole at
the back of the basin. From the back of the fountain, use the
connecting plates with the large screws and washers to attach
the top fountain to the basin. Align the mounting holes at the
base of the iron rack with the holes on the top of the basin and
secure the fountain top to the basin using four large bolts and
washers.
4.
Place each of the two candle cup holders to the steel rack in the
indented areas and secure with two small screws for each
holder. These holders can be used to hold the small glass
candle cups.
5.
Carefully slide the two finger lamps into the lamp clips in the
small basins on the fountain top. Connect the pump output
cords to the finger lamp power cords at the back of the fountain.
6.
Attach the water supply tube from the underside of the fountain
top to the pump outlet on top of the pump. Make sure the pump
sits flat with the outlet facing upwards. If applicable, adjust the
flow rate of the pump is set to the maximum (+) position. Place
the cover over the pump housing making sure to guide the lamp
power cord through the notch of the pump cover.
7.
Fill the basin with clean water. Do not fill past water line
marked on the inside edge of the basin.
8.
Connect the pump power cord to the transformer and then
connect the transformer to a GFCI outlet
.
Turn your power
source on and the fountain will start to flow.
9.
If applicable, adjust the flow rate of the pump to the desired
level. Remember to always disconnect the pump from the
power source before making any adjustments to the pump or
lights.
10.
If you are experiencing excessive splashing, you can place the
mesh screen over the top of the fountain base
on top of the tabs
to prevent water from splashing out.
