Platform - Safety Rail Assembly
Platform - Safety Rail Assembly
M6 x 45
Patch-Lok
M6 x 40
M6 x 70
M6 x 70
Illustration 1
Illustration 2
Illustration 3
Illustration 4
IMPORTANT
:
To avoid assembly problems follow these instructions exactly.
Note
: If assembling the platform with Folding Safety Rails first read the seperate instructions included with the
Folding Safety Rail Bracket Kit.
Step 1
-
Fix the Rear Safety Rail to the rear of the Platform Kickrail. Use the M6 x 45mm Patchlok bolts (blue
coated) and screw in with the hexagon key leaving the bolt slightly loose (See illustration No. 1)
Note:
Do NOT use Pnuematic or Electric drivers with Patch-Lok Fixings
Step 2
-
Fix the Lower LH Side Safety Rail to the Platform Kickrail. Slide the Safety Rail into the Kickrail. Place a M6 x
40mm bolt through the top hole at the front of the Kickrail and fit a nut -
Finger tight only
. (See illustration No. 2)
Step 3
-
Fix the Lower LH Side Safety Rail to the Rear Safety Rail using two M6 x 65 bolts and nuts -
Finger tight
only.
(See illustration No. 3)
Step 4
-
Fix the Upper LH Side Safety Rail to the Rear Safety Rail using two M6 x 65 bolts and nuts.
Finger tight
only.
(See illustration No. 4)
Step 5
-
Fix the Upper LH Side Safety Rail to the Lower Side Safety Rail.
Finger tight only.
(See illustration No. 5)
Repeat steps 2 to 5 for the other side rails.
PRO Version repeat steps 2 & 3 only. Do not fit the RHS Upper Side
Safety Rail
Step 6
-
Check that the rails are all alligned and use the hexagonal key and spanner to tighten all bolts. The M6
bolts must be tightened untill the screw end is flush with the back of the nut. (See illustration No. 6)
1
2
