1 | User information
10/2019 | ID 443150_en.00
5
Information
Information indicates important information about the product or serves to emphasize a section in the documentation that
deserves special attention from the reader.
Embedded warning information
Embedded warning information is integrated directly into the instruction manual and is structured as follows:
SIGNAL WORD! Type of hazard, its cause and possible consequences of disregarding it! Measures for avoiding the hazard.
Signal words in embedded warning information have the same meaning as in the normal warning information described
previously.
1.4
Terms
This documentation describes both STOBER gear units and gear components of STOBER geared motors. For reasons of
clarity, the collective term drives is used for these.
1.5
Supporting documents
Separate documents apply to the drive components which can be attached to STOBER gear units, depending on the design.
These documents can be found by entering the serial number of the gear unit at
or by scanning the
QR code on the nameplate of the gear unit.
Alternatively, you can find supporting documents at
http://www.stoeber.de/en/downloads/
. Enter the ID of the
documentation in the Search... field:
Drive components
Operating manual ID
LM Lean motor
443048_en
EZ synchronous servo motor
443032_en
MB motor adapter with brake
441846_en
1.6
Limitation of liability
This documentation was created taking into account the applicable standards and regulations as well as the current state of
technology.
STOBER shall assume no responsibility for damage resulting from failure to comply with the documentation or from use
that deviates from the intended use of the product. This is especially true for damage caused by individual technical
modifications to the product or projecting and operation of the product by unqualified personnel.
1.7
Product names and brands
Product names that are registered as brands are not specifically identified in this documentation. Existing property rights
(patents, trademarks, protection of utility models) are to be observed.
1.8
Copyright notice
Copyright © STOBER. All rights reserved.
