Reflector
Bezel
1
2
3
Pan
Tilt
Accessories
Circlip
MODULE AND ACCESSORIES
The fitting uses a Xicato XIM LED module. The colour
temperature and lumen output can be found on the
product label on the fitting.
To add/remove accessories:
Isolate the fitting from the supply and allow to cool.
Step 1 To replace accessories remove circlip and load
accessories. Reattach circlip to secure.
Step 2 To replace optic/reflector unscrew bezel in an
anti clockwise direction.
Step 3 Remove old optic/reflector and fit new reflector.
Refit the bezel by screwing on in a clockwise
direction.
Note that the 9mm XIM uses an optic, while the 19mm
XIM modules use screw in reflectors. These are not
interchangable.
ADJUSTMENT
To adjust the tilt and pan of the fitting use the supplied
2.5mm Allen key to loosen off the tilt and pan lock screws.
Once the desired angle is achieved lock off the screws.
DO NOT
over tighten the screws as this could damage
the lock and cause it to no longer function.
STX2.70 Integral.pdf 4 16/04/2020 09:22:13