Warning: Please read directions completely before starting. If you have any
questions, please contact BMPP before beginning your installation. Also, please
check our website (www.stonsho.com
)
for any updates or changes. Thank You.
Parts Included:
License Plate mounting bracket Assembly. Includes Base Plate and
License Plate Holder.
License Plate Mounting Screws: (2) 6mm X 12mm (Phillips head), (2) 6mm
nuts (10mm wrench size)
Base plate mounting bolts: (2) 6mm X 20mm with washers, lock washers
& nuts
Tools Needed:
10mm, and 13mm sockets with ratchet
Phillips screwdriver and 10mm wrench
¼” drill bit and drill
Step 1: Ensure all parts listed above are accounted for. Note: If at any time during the
installation process you need assistance please call (408) 776-4080.
Step 2: Separate the license plate holder from the base by simply pulling the pull pin ring
outward and sliding apart.
Step 3: Remove lower skid plate as shown in figure 1 by removing the front (4) 13mm headed
bolts as shown in figure 2 and loosening the rear (2) 13mm headed bolts shown in figure 2a.
Note: There will be bolts on the left and right side.
Step 4: Align base plate with back edge of lower bumper and center base plate as shown in
figure 3. Slide the front bracket into the tubes to verify alignment. Remove when alignment is
complete and continue to step 5.
Step 5: Once base plate is correctly positioned carefully drill two 1/4" holes for the mounting
bolts only. See figure 4.
Step 6: Install base plate using the two 6mm bolts and nuts included by pushing bolts and
washers through mounting holes and attaching lock washers and nuts on top. Note: Access to
the top is gained by lowering the skid plate in step 1. Once base plate is secured, re-install the
(4) bolts removed to lower skid plate and tighten all (6) bolts and proceed to step 7.
Step 7: Secure the license plate and frame (optional) to the license plate bracket using the two
screws and nuts provided. Requires the Phillips screwdriver and 10mm wrench (Not included).
Summary of Contents for SNS 115
