STMicroelectronics STEVAL-MKI109V2, User Manual

Page: 26 / 39

4.2.5 Analog output gyroscopes: supported commands
Table 9. Analog output gyroscopes: supported commands list below lists the commands supported by the
devices/demonstration boards including an analog output gyroscope.
Table 9. Analog output gyroscopes: supported commands list
Command Description Returned value
*setdbXXXVY Selects firmware according to the adapter connected
*start Starts continuous data acquisition (see Table 4. Returned values for *start command )
*debug Returns the output data in readable text format (see Table 5. Returned values for *debug command )
*stop Stops data acquisition
*Zon Forces 3-state
*Zoff Exits from 3-state
*dev Device name e.g.: LIS3DH
*ver Firmware version e.g.: V1.0
*single It gets a single X, Y, and Z data acquisition (see Table 5. Returned values for *debug command )
*list Prints the list of MKIs supported e.g.: MKI105V1
*listdev Prints the list of devices supported e.g.: LIS3DH
*echoon Activates the write verbose mode e.g.: RAAhDDh
*echooff Deactivates the write verbose mode
*PDON Sets power-down pin
*PDOFF Clears power-down pin
*STON Sets self-test pin
*STOFF Clears self-test pin
*HPON Sets high-pass filter pin
*HPOFF Clears high-pass filter pin
UM0979
Supported commands
UM0979 - Rev 6
page 26/39