STM AUSTRALIA
1/615 WARRIGAL RD
ASHWOOD VIC 3147
AUSTRALIA
T
1300 131 531
F
1300 308 508
E
W
WWW.STM.NET.AU
DG83231 18 Volt 450 Gram Grease Gun
WARNING
1. Do not use battery charger in damp or wct locations. Do not use the Grease Gun or Charger if it has been dropped,
damaged, left outdoors, or immersed in liquid. To avoid electrical shock, do not handle the charger, its power cord plug,
or the Grease Gun with wet hands.
2. Grease Gun can develop high pressure - up to 10,000 PSI. Use safety glasses and gloves for protection during opera-
tion. Keep hands clear of the exposed rubber portion of Hose:
3. Extreme pressure may cause Nozzle extension or Flex Hose to burst. Use only APPROVED hoses and follow whip hoxe
instructions and warnings.
SAVE THIS MANUAL
You will need this manual for the safety warnings and precautions, assembly, operating, maintenance and cleaning
procedures.
Make sure power circuit voltage is the same as that shown on the charger specification plate Connect charger to power
source.
INSTALLING OR REMOVING BATTERY PACK TO REMOVE BATTERY PACK
Depress the two battery release buttons (one button on each side of battery pack) and pull battery pack out of grease gun
NORMAL CHARGING
Make sure power circuit voltage is the same as that shown on the charger specification plate Connect charger to power source.
Removing Empty Grease Cartridge
1) Pull back on the follower handle until the follower rod is fully extended and latch the follower rod groove into the slot on
the tube end cap of the Grease Tube
2) Unscrew the grease tube assemble from the gun.
3) Carefully release ihe follower handle to eject the empty cartridge from container tube
1) Remove the plastic cap from the grease cartridge and insert cartridge into the container tube.
2) Remove the pull tab from grease cartridge and screw grease tube into pump assembly
3) Release follower rod from slot to allow it to go forward. Purge air from pump.
See air purging instructions
HOW TO INSTALL A GREASE CARTRIDGE
CHARGER OPERATION
CHARGING THE BATTERY PACK GENERAL
Before using Grease Gun for the list time, if the battery pack is installed in the gun,
remove it by depress the two battery release butions (one button on each side of
battery pack) and pull battery pack out of gun.
As a battery pack approaches the discharged state, you will notice a sharp drop in
tool performance. When the tool is unable to perform the task at hand, it is time to
recharge the battery pack. Recharging the battery pack before this condition is
reached will reduce the total work life of the pack. Discharging the pack beyond this
point can damage the pack.
Start the charging process by plugging in the battery charger and inserting the
battery into battery charger slot After Termination of the charging (approx. 1-2h),
pull charger out of socket and remove battery.
NOTE
Battery temperature will increase during and shortly after use. Batteries may not accept a full charge if they are
charged immediately after use. Allow the battery pack to cool to room temperature before charging for best results.
Insert the Battery Pack into the Charging Socket of the Charger. Then: plug the Charger into the nearest 230 volt, grounded,
electrical outlet. To start charging press the “Set” button on the Charger. Battery is charging when the green light
illuminates.
Installing Grease Cartridge
