REAR RAPTOR® SERIES
SpeedTech Lights, Inc © 2018
5
Wiring: Connecting Wires to Control Box
•
This unit will feature a power harness with eight (8) colored leads with a connector that plugs into the Direct Control® Box. When not utiliz
ing the Direct Control® Box reference the Wiring Diagram above.
•
Now that you have pulled the cable into the vehicle attach the connector back to your Light Bar’s wire harness in the CORRECT positions
using a pin pusher and plug it into your Cigarette Lighter Plug. If you do not know the correct position of each wire in the connector call
customer service at 800-757-2581 before proceeding.
•
If you did not purchase the Direct Control® Box and are using your own switch box , wire the cables accordingly into your control panel by
referencing the wiring diagram and instruction manual of your control panel.
•
Wiring: Connecting Extension Cables
•
This unit will feature a power harness with eight (8) colored leads with a connector that plugs into the Direct Control® Box.
•
If you have an extension cable with connectors, connect the corresponding ends to one another. Use the connector at the end of the cable
to plug into your control box.
•
If you have an extension cable with one connector, you will need to cut the connector off of the main cable harness coming out of the Light
Bar. Save it as a spare part. You will solder, and heat shrink each wire within the cable harness to each wire in the extension cable harness.
DO NOT cross connect wires. Use the connector at the end of the extension cable to plug into your control box.
•
If you have an extension cable with no connectors, you will need to cut in the middle of the main cable harness coming out of the Light
Bar. You will solder, and heat shrink each wire within the cable harness to each wire in the extension cable harness. DO NOT cross connect
wires. Use the connector at the end of the main cable harness to plug into your control box. DO NOT leave connectors, cables, solder points
exposed to heat or moisture or debris.
Programming Flash Patterns
•
All STL LED products are equipped with a non-volatile memory which will recall the last flash pattern when the Light Bar is turned on.
•
Set your flash pattern by pushing the Flash Pattern button on your Direct Control® Box to cycle through the various patterns until you find
the appropriate pattern.
•
If you are not using the Direct Control® Box you will follow the wiring diagram to identify the Flash Pattern wire to manually run through
and select the desired flash pattern.
Maintenance
While STL’s Light Bars are very durable, there are some things you need to keep in mind and practice to preserve the longevity and function of
your bar.
•
Never take any STL Light Bars through a car wash, such as a pressure washer, automatic car wash, brushes that will scratch your equipment
or similar car washes or equipment where chemicals, high pressure water, and materials may scratch or damage your equipment.
•
Use Water (H2O) with a soft cloth to clean your Light Bar and lenses.
•
Yellowing of clear lenses may occur overtime. Lenses can be purchased by calling STL Customer Service at 800-757-2581.
All rights reserved. No part of this Operations Manual and Instructions may be reproduced, distributed, transmitted, or otherwise shared in any form or by any means, including but not limited to photocopying, recording,
electronic delivery, .pdf reproduction, or any other means of reproducing all or any part hereof without the express prior written consent of the SpeedTech Lights, Inc., except for non-commercial purposes as permitted
by United States copyright law. Customers of SpeedTech Lights, Inc., may download and print this Operations Manual and Instructions for use with products sold to the customer by SpeedTech Lights, Inc. However, no
part of the Operations Manual and Instructions may be otherwise or subsequently reproduced, downloaded, disseminated, published, or transferred, in any form or by any means, except with the prior written consent
of SpeedTech Lights, Inc.
