PLEASE READ BEFORE USING YOUR
STINGER TRAILER
1. Remove all three (3) pins before unfolding trailer.
2. Trailer must be hooked to vehicle before loading or unloading motorcycle.
3. Be certain that both ½” pins are installed in trailer before loading motorcycle. Also, be sure to use
the snap-over keeper pins located at each location. The 3/8” pin holds ramp upright after loading.
4. Place steel tube under rear of trailer before loading or unloading bike. See diagram.
5. Read instruction label located on trailer tongue.
6. Bearings should be greased every 2,000 miles OR annually.
7. Trailer comes with electrical plug. Owner needs to wire towing vehicle. (Some vehicles may require
an inverter).
8. Inflate tires evenly (35-70 lbs as preferred) at all times.
9. Trailer must be level once mounted. Adjustable ball mounts work well for this.
10. When folding and unfolding trailer, use the front tie-down bar as a handle. Make sure hands are
not placed at the folding sections of the trailer when folding and unfolding to avoid pinching of
hands.
11. Check bolts on trailer periodically. Especially fenders!
12. Be careful not to pinch electrical cable when folding trailer.
13. Be sure to use at least four (4) ratchet type straps to tie down bike
14. Be sure to read cradle setting to set chock for your tire.
15. The galvanized bushing that is in between the brass washers is a spacer for the hole in the ball
mount.
Visit
www.stingertrailer.com
for video demonstration
