© stilum GmbH, Gewerbegebiet Larsheck, 56271 Kleinmaischeid • Tel. +49 (0) 2689 92790-0 • All rights and product modifications reserved.
State: 16.06.2016 p. 3
Mounting instructions for seesaw „libra 2“
Item No. 512511401
Diagram 3: Top view „libra2“
5500
2800
Behnke
Mindestraum
Libra 2
OHNE SCHRIFTLICHE ZUSTIMMUNG DER C KAISER GMBH DARF DIESE TECHNISCHE UNTERLAGE WEDER VERVIELFÄLTIGT
NOCH DRITTEN MITGETEILT ODER ZUGÄNGLICH GEMACHT WERDEN NOCH IN SONSTIGER WEISE MISSBRÄEUCHLICH VERWENDET
WERDEN. ZUWIDERHANDLUNGEN WERDEN URHEBERRECHTLICH VERFOLGT.
WERKSTOFF / ROHMAß:
MAßSTAB:
OBERFLAECHEN NACH
DIN ISO 1302 REIHE 2
ZUL. ABWEICHUNG
DIN 2768 - mH
WERKSTUECKKANTEN
NACH DIN 6784
+0,3
-0,3
FREIG:
GEPR:
GEZ:
DATUM:
NAME:
Gewerbegebiet Larsheck
56271 Kleinmaischeid
Deutschland
BENENNUNG:
BESTELL-NR:
ZG-NR:
07.04.2016
Rev.:
KUNDE:
A4
6. Seal the foundation with the safety cover required for the height of fall indica-
ted. Set up impact-absorbing playground surfacing according to EN 1177 HIC
1000.
Recommended surface material: grass, sand, wood chip, gravel, synth. fall
protection. (Critical drop height ≤ 1000 mm)
7. Please make sure that suitable impact-absorbing elements (made of caout-
chouc, for example) have been fi rmly installed in the underground below the
touch points of the seesaw ends.
8. Do not allow children to use the equipment before the installation has been
finished.
Attention:
If the play equipment has been incompletely installed or partly dis-
mantled when carrying out maintenance and repair work, this may lead to par-
ticular risks of injury for the user. For this reason, make clearly visible that the
equipment shall not be used in such cases.
NOTE:
Play equipment, which contain components made of stainless steel
should not come with „normal“ steel parts in contact. Those steel parts may rub
off and leave small steel particles in combination with moisture brown rust stains.
If such corrosion occur on stainless steel parts, they are fine with an abrasive
(240 grit) to remove.
Please take care when transporting and setting up the fact that the components
are made of stainless steel with no „normal“ steel parts in contact.
