© stilum GmbH, Gewerbegebiet Larsheck, 56271 Kleinmaischeid • Tel. +49 (0) 2689 92790-0 • All rights and product modifications reserved
Stand: 22.01.2019 S. 2
Mounting instructions bouncing element „jump XL“
Item no. 51462x250
Diagram 2: Combined frost protection and load bearing layer
Diagram 3: Cut through installed Bouncing Element Jump XL
1. Select the play equipment location in consideration of the requried
safety area (s. diagram 4: 6500 x 5500 mm).
2. Carry out excavation work for the foundation as shown in diagram 3.
pit size: (LxWxH) 3100 x 2100 x 600 mm
excavation of the pit: 3,906 m³
Needed combined frost protection and load bearing layer material:
1,041 m³
Note
: Lifting equipment is needed
3. Create combined frost protection and load bearing layer as shown in
diagram 2.
4. Screw the eyebolts into the existing holes and use as lifting point.
5. Lift Bouncing Element Jump XL and place it in the middle of the pit.
6. Unscrew eyebolts.
7. Fill the gap with parts of excavation.
8. Think about safety surface
9. For a maximum fall height of 1000 mm safety surface must be accor-
ding to EN 1176-1, chart 4.
For a bouncing element, the extent of the clearance must be 2000
mm horizontally around the jump surface, measured at each point of
the edge, and 3500 mm above the jump surface.
10. Do not allow children to use the equipment before the installation
has been finished.
Attention:
If the play equipment has been incompletely installed or partly
dismantled when carrying out maintenance and repair work, this may
lead to particular risks of injury for the user. For this reason, make clearly
visible that the equipment shall not be used in such cases.
5
Drawing 2: Combined frost protection and load bearing layer
6
Drawing 3: Cut through installed Bouncing Element Jump XL
