Wiring Instructions
The preferred method of bringing input signal into the KX2 crossover is with
RCA cables from a quality source unit, such as an aftermarket CD player. A high
level (speaker) input may also be used if your factory deck or aftermarket source
does not have low-level RCA jacks.
Power for the KX2 should always come from a fused source. If you are using
an aftermarket head unit it is convenient to tap into the sources constant power
lead for main power and add to the remote output for turn on.
If you are using a source which does not have a remote turn on lead the KX2
can be turned on with a switched accessory lead. You can find this accessory
power source in the factory harness at the back of the radio. It is the lead that
turns on and off with the key.
To reduce the chance of noise entering the system, it is recommended that
the RCA cables be run through the vehicle separate from any power wires.
2
Connect the CO12V and the 12V wires to the correspon-
ding accessory wires from the source units factory harness.
The GROUND wire needs to be securely connected to a place on the body of
the vehicle, close to the KX2, that is clean of paint and rust.
R
The KX2 crossover can be mounted in any convenient location in your vehicle
that allows access to the controls and freedom from moisture. The flanges on
the chassis have mounting holes which can be used as a template for the screw
holes.
Mounting Instructons
