Still RX70 Series, Original Instructions Manual

Page: 324 / 406

5
Maintenance
Safety regulations for maintenance
Safety devices
After maintenance and repair work, all safety
devices must be reinstalled and tested for
operational reliability.
Set values
The device-dependent set values must be
observed when making repairs and when
changing hydraulic and electrical compo-
nents. These are listed in the appropriate
sections.
Lifting and jacking up
DANGER
There is a risk to life if the truck tips over!
If not raised and jacked up properly, the truck may
tip over and fall off. Only the hoists specified in the
workshop manual for this truck are allowed and are
tested for the necessary safety and load capacity.
– Only have the truck raised and jacked up by the
authorised service centre.
– Only jack the truck up at the points specified in
the workshop manual.
The truck must be raised and jacked up for
various types of maintenance work. The
authorised service centre must be informed
that this is to take place. Safe handling of
the truck and the corresponding hoists is
described in the truck's workshop manual.
Working at the front of the truck
DANGER
Risk of accident!
If the lift mast or fork carriage is raised, no work
may be performed on the lift mast or at the front of
the truck unless the following safety measures are
observed.
– When securing, only use chains with sufficient
load-bearing capacity.
– Contact the authorised service centre.
312 57348011800 EN - 11/2018