Still RX60 35-50, Original Instructions Manual

Page: 56 / 596

Changes to the overhead guard
and roof loads
DANGER
In the event of the overhead guard failing due to
a falling load or the truck tipping over, there are
potentially fatal consequences for the driver. There
is a risk to life!
Welding and drilling on the overhead guard changes
the material characteristics and the structural design
of the overhead guard. Excessive forces caused by
falling loads or the truck tipping over may result in
buckling of the modified overhead guard and no pro-
tection for the driver.
–
Do not perform welding on the overhead guard.
–
Do not perform drilling on the overhead guard.
CAUTION
Heavy roof loads damage the overhead guard!
To ensure the stability of the overhead guard at all
times, a roof load may only be mounted on the over-
head guard if the structural design has been tested
and the manufacturer has given approval.
–
Seek advice from the authorised service centre for
the mounting of roof loads.
Warning regarding non-original
parts
Original parts, attachments and accessories
are specially designed for this truck. We spe-
cifically draw your attention to the fact that
parts, attachments and accessories supplied
by other companies have not been tested and
approved by STILL.
CAUTION
Installation and/or use of such products may there-
fore have a negative impact on the design features
of the truck and thus impair active and/or passive
driving safety.
We recommend that you obtain approval from the
manufacturer and, if necessary, from the relevant
regulatory authorities before installing such parts.
The manufacturer accepts no liability for any damage
caused by the use of non-original parts and accesso-
ries without approval.
Safety
2
Basic principles for safe operation
40 56388011501 EN - 05/2022 - 08