Still FXD 20 N, Original Instructions Manual

Page: 70 / 142

4
Use
Operating the FleetManager™ option
Commissioning a truck equipped
with the FleetManager™ option
Commissioning a truck equipped with a
keypad or an electronic key
– Turn the switch key to start the truck.
– Enter the PIN code on the keypad. The PIN
code consists of five to eight digits.
By default, no PIN code is given as a factory
setting.
If the PIN code is correct, the LED (1) is not
lit. The LED (2) flashes slowly at two-second
intervals (green colour).
No acoustic signal sounds.
– Press the Enter key (3) to confirm.
The truck is now ready for use.
NOTE
In the configuration, the fleet manager can
specify that the operator must enter a prelimi-
nary code when logging in. The operator can
then assess the state of the truck.
Commissioning a truck equipped with an
RFID reading device
– Turn the switch key to start the truck.
– Place the RFID transponder card or the
RFID transponder (4) in front of the reading
device (3).
If the card is correct, the LED (1) is not lit. The
LED (2) flashes slowly at two-second intervals
(green colour).
Two acoustic signals sound.
The truck is now ready for use.
60 11648011651 EN - 09/2019