Picking up a load at a height
Proceed as follows:
–
Drive the truck to the required location.
–
Lower the load arms completely.
–
Lift the forks to the height of the pallet.
–
Carefully move the forks forward under the
pallet.
–
Lift the forks until the pallet is lifted free of
the rack.
–
Move slowly to withdraw the forks from the
rack.
DANGER
Risk of hooking the mast on the rack
Do not start lowering the forks until they are com-
pletely clear of the rack. The forklift operator must re-
main vigilant and ensure that there are no obstacles
preventing the lowering of the forks.
–
With the load on the forks, lower the forks
again until they reach the ground.
–
Lift the load arms to move the truck.
Before leaving the truck
NOTE
Always stop the truck on level ground away
from traffic routes.
Proceed as follows:
–
Lower the forks to the lowered position.
–
Switch off the ignition (key or electronic
key).
–
In the event of a prolonged shutdown, press
the emergency off switch. Then disconnect
the battery.
Use
4
Transporting loads
71
11638011551 EN - 02/2021 - 06
Summary of Contents for EXD 20
