with these regulations either intentionally or
carelessly.
Stability
The stability of the truck has been tested to
the latest technological standards and is guar-
anteed provided that the truck is used properly
and according to its intended purpose. These
standards only take into account the dynamic
and static tipping forces that can arise during
specified use in accordance with the operating
rules and intended purpose. However, the
danger of exceeding the moment of tilt due to
improper use or incorrect operation and losing
stability can never be excluded.
The loss of stability can be avoided or mini-
mised by the following actions:
–
Always secure the load against slipping,
e.g. by lashing.
–
Always transport unstable loads in suitable
containers.
–
Always drive slowly when cornering.
–
Drive with the load lowered.
–
Even with sideshifts, align the load as cen-
trally as possible with the truck and trans-
port in this position.
–
Avoid turning and diagonally driving across
slopes or gradients.
–
Never have the load facing downhill when
travelling on slopes or gradients.
–
Pick up only loads of the approved width.
–
Always take great care when transporting
suspended loads.
–
Do not drive over ramp edges or steps.
Special risks associated with us-
ing the truck and attachments
Approval from the manufacturer and attach-
ment manufacturer must be obtained each
time the truck is used in a manner that falls
outside the scope of normal use, and in cases
where the driver is not certain that he can use
Safety
2
Residual risk
24
5001 801 1532 EN - 10/2021 - 03
Summary of Contents for ECH 12C
