Still CX-T-40, Original Instructions Manual

Page: 69 / 146

Operation
5
Driving
immediately when eye contact wit the guide is
lost.
Before driving
Persons in the danger area
Before starting up, the driver must ensure that
no person is standing in the danger area of the
truck. If persons are at risk, a warning signal
must be given in time. Stop work with the truck
at once if persons do not leave the danger
zone despite warning.
Danger zone
The danger zone is the area in which persons
are endangered through the movement of the
truck, its implements, load-lifting devices (eg
attachments) or the carried load. This also
includes the area within the range of falling
loads or a descending implement.
Dimensions of roadways and working
aisles
The dimensions specified in the description
section apply under established conditions
and should ensure safe manoeuvring. Check
in each case whether a wider aisle is required
when, for example, the load dimensions
deviate.
Observe your local and national regulations.
The truck may only be used on roadways
without too tight curves, too large gradients
and too narrow and too low passages.
Condition of roadways
Roadways must be solid enough, free of
debris and fallen objects. Drainage ducts,
railway crossings and the like must be level
and, if necessary, provided with ramps so that
they can be crossed without jolts, if possible.
There must be sufficient clearance between
the highest parts of the truck or load and fixed
parts of the surroundings. The height depends
on the lift height and the dimensions of the
load. Check the data sheet for your truck.
51048070007 [EN] 61