SG 11 , SG 11 PLUS
English
4
Avoid contact with plant protection
products/cleaning agents.
Plant protection products/cleaning
agents may be used only by persons
trained in their handling and the
appropriate first-aid measures.
Keep instructions or label of the plant
protection/cleaning product available at
all times in order to inform the doctor
about the chemical concerned in an
emergency. In an emergency, follow the
instructions on the product label or in the
directions for use. Observe
manufacturer's safety data sheets.
Mixing plant protection/cleaning product
and filling sprayer
Always follow manufacturer's
recommendations for use of plant
protection/cleaning product.
–
Before filling the tank with
chemicals, carry out a test with fresh
water and check all parts of the
sprayer for leaks.
–
Never apply undiluted liquid
concentrates of plant
protection/cleaning products.
–
Prepare solution and fill the sprayer
outdoors only or in well-ventilated
locations.
–
Only prepare sufficient solution for
the job in hand so that no surplus is
left in the tank.
–
Do not mix different plant
protection/cleaning products unless
such a mixture is approved by the
manufacturer.
–
Mix different plant
protection/cleaning products only in
accordance with the manufacturer's
instructions – incorrect mixtures
may produce toxic fumes or
explosive solutions.
–
Stand the sprayer on a level surface
– do not fill the tank above the
maximum mark.
–
When filling from a central water
supply, do not immerse the end of
the hose in the solution – sudden
low pressure in the system may
cause the solution to be sucked
back into the water supply.
–
Close the tank tightly after filling.
Application
–
Work only in the open or in very well
ventilated locations, e.g. open
greenhouses.
–
Do not eat, drink or smoke while
working with plant
protection/cleaning products.
–
Never blow through nozzles or other
components by mouth.
–
Do not spray in windy conditions.
Too high or too low a spray pressure or
unfavorable weather conditions can
result in the wrong solution
concentration. Too high a dose may
harm the surface, plants or the
environment. Too low a-dose may result
in unsuccessful treatment.
In order to reduce the risk of damage to
surfaces, plants and the environment,
do not operate the sprayer:
–
if pressure is too high or too low
–
in windy conditions
–
at temperatures above 30 °C in the
shade
–
in direct sunlight
In order to reduce the risk of accidents
and damage to the sprayer, never
operate the sprayer with:
–
flammable liquids
–
viscous or sticky liquids
–
caustic or corrosive chemicals
–
liquids hotter than 30 °C
Storage
–
During work breaks, do not leave
the sprayer in the hot sun or near
any heat source.
–
Never store plant protection
products/cleaning agents in the tank
for longer than one day.
–
Store and transport plant protection
products/cleaning agents only in
approved containers.
–
Never store plant protection
products/cleaning agents in
containers intended for foods,
drinks or animal feed.
–
Do not store plant protection
products/cleaning agents together
with foods, drinks or animal feed.
–
Keep plant protection/cleaning
products out of reach of children
and animals.
–
Store the sprayer empty and clean.
It must not be under pressure.
