EN
59
0478 131 8349 A - EN
14.3 Active times
During the active times, the robotic mower
is allowed to leave the docking station and
mow the lawn. During these times,
mowing operations
,
charging
operations
and
rest periods
take place.
The robotic mower automatically
distributes the mowing and charging
operations between the available time
windows.
During installation, active times are
automatically distributed over the entire
week. Time reserves are taken into
account – this ensures perfect lawn care,
even if individual mowing operations
cannot take place, (e.g. due to rain).
14.4 Mowing duration
The mowing duration specifies how many
hours per week the lawn is to be mown. It
can be extended or reduced in the weekly
settings (
The mowing duration corresponds to the
time during which the robotic mower mows
the lawn. Times during which the battery is
charged are not part of the mowing
duration.
During initial installation, the robotic
mower automatically calculates the
mowing duration based on the specified
size of the mowing area. This reference
value is based on a normal lawn under dry
conditions.
Mowing performance:
For 100 m
2
, the robotic mower needs on
average:
14.5 Home area (RMI 632 C,
RMI 632 PC)
The robotic mower identifies its location
using the built-in GPS receiver. During
each edge following run to check the
correct wire routing (
entering in the starting points (
the robotic mower stores the coordinates
of the most westerly, easterly, southerly
and northerly point.
This area is defined as the home area and
the robotic mower can be used here. The
coordinates are updated each time edge
following is repeated.
When
GPS protection
is activated, the
owner of the machine is notified if the
machine is operated outside the home
area. The PIN code is also requested on
the robotic mower display.
14.6 Manual mowing
Do not activate the mowing blade or set
the lowest cutting height in high grass.
The robotic mower load must never cause
the mowing motor speed to drop
significantly. If the speed drops or the
robotic mower slows down, select a higher
cutting height setting.
15.1 Preparation
●
●
the perimeter wire
●
Remove foreign bodies (e.g. toys,
tools) from the mowing area
●
●
●
Check the mowing plan and adapt if
necessary – in particular it must be
ensured that third parties keep away
from the danger area during active
times. (
During the active times, third
parties must keep out of the danger
area. The active times should be
adapted accordingly.
Moreover, the applicable local
regulations on the use of robotic
mowers as well as the information
in the "For your safety"
section (
and the active times changed
accordingly in the "Mowing plan"
menu as required. (
In particular, you should check the
times of the day and night at which
it is permissible to use the machine
with the responsible authorities.
RMI 632, RMI 632 C:
70 minutes
RMI 632 P,
RMI 632 PC:
60 minutes
15. Operating the machine
An installation assistant is available
for
initial installation
The robotic mower should be
charged and operated at an
ambient temperature b5°C
and +40°C.
Mow very high grass until it is short
using a conventional lawn mower
prior to use of the robotic mower
(e.g. following a lengthy break).
