Stihl RE 90.0, Instruction Manual

Page: 36 / 288

1
3
2
0000098893_001
► Unscrew the connector (1).
► Insert water intake screen (2) into the coupling
of the water hose (3).
Connecting the water hose
3
4
2 1
1
0000098894_001
► Fill the water hose (1) with water so that no air
is present in the water hose any more.
► Screw the coupling (2) onto the connector of
the pressure washer (3) and tighten by hand.
► Attach the suction cup (4) to the water source
so that the suction cup (4) does not touch the
ground.
► If the spray gun is fitted to the high-pressure
hose: Remove the spray gun.
► Hold the high-pressure hose downwards.
► Switch on the high-pressure washer until an
even water jet flows out of the high-pressure
hose.
NOTICE
■ If the high-pressure washer does not suck in
water, the pump may run dry and the high-
pressure washer may be damaged.
► If no water escapes from the high-pressure
hose after two minutes: Switch off the high-
pressure washer and check the water sup‐
ply.
► Switch off the high-pressure washer.
► Connect the spray gun to the high-pressure
hose.
► Press and hold down the spray gun trigger.
► Switch on high-pressure washer.
8 Connecting the pressure
washer to the power supply
8.1 Connecting the pressure
washer to an electric power
supply
2
0000-GXX-5304-A0
1
3
3
► Set the toggle switch to the 0 position.
► Remove the connecting cord (2) from the hold‐
ers (3).
► Plug the plug of the connecting cord into a cor‐
rectly installed socket.
9 Switching the pressure
washer on and off
9.1 Switch on high-pressure
washer
When the pressure washer is switched on, volt‐
age fluctuations may occur under unfavorable
mains conditions. The voltage fluctuations may
negatively affect other connected electrical appli‐
ances.
0000-GXX-5305-A0
► Set the rocker switch to position I.
English 8 Connecting the pressure washer to the power supply
36 0458-002-9821-B