Stihl Msa 200 c, Instruction Manual

Page: 56 / 352

MSA 200 C
English
54
–
In the event of smoke or fire in the
charger, disconnect it from the wall
outlet immediately.
–
To reduce the risk of electric shock
or short circuit, do not insert any
objects in the charger's cooling
slots.
–
Do not operate on an easily
combustible surface (e.g. paper,
textiles) or in an easily combustible
environment – risk of fire.
–
Do not operate in a hazardous
location, i.e. in a location where
there are combustible liquids
(fumes), vapors or dusts. Chargers
can produce sparks, which may
ignite the dust or vapors – risk of
explosion.
–
Never jerk the power cord to
disconnect it from the wall outlet. To
unplug, grasp the plug, not the cord.
Have a damaged power cord
repaired by a qualified electrician.
–
Do not use the connecting cord for
any other purpose, e.g. for carrying
or hanging up the charger.
–
Never use connecting cords that do
not comply with regulations.
–
Position and mark the power supply
cord so that it cannot be damaged
or stepped on, tripped over or
endanger others.
To reduce the risk of electric shock:
–
Always connect the power cord to a
properly installed wall outlet.
–
Make sure the insulation of the
power cord and plug is in good
condition.
Unplug the power supply cord from the
wall outlet when the charger is not in
use.
Notes on Operation
–
before carrying out tests and
adjustments or cleaning work
–
before working on the cutting
attachment
–
before leaving the machine
unattended
–
when transporting
–
storing the machine
–
before performing repairs and
maintenance work
–
in the event of danger or in an
emergency
This avoids the risk of the motor starting
unintentionally.
Before starting work
Check that your power tool is properly
assembled and in good condition – refer
to appropriate chapters in the instruction
manual.
–
Check operation of chain brake,
front hand guard
–
Correctly mounted guide bar
–
Correctly tensioned chain
–
The trigger and trigger lockout must
move freely and spring back to the
idle position when they are
released.
–
Trigger is locked in position when
trigger lockout is not depressed.
–
Never attempt to modify the controls
or safety devices in any way.
–
Keep the handles dry and clean –
free from oil and dirt – for safe
control of the power tool.
–
Check contacts in battery
compartment for foreign matter.
–
Fit the battery correctly – it must
engage audibly.
–
Never use defective or deformed
batteries.
To reduce the risk of accidents and
personal injury, do not operate the unit if
it is not properly assembled and in good
condition.
Switch on machine
Place the unit on a firm surface. Make
sure you have good balance and secure
footing. Hold the unit securely. The
cutting attachment must be clear of the
ground and all other obstructions.
Check the charger's
power supply cord regu -
larly for damage. If the
power supply cord is
damaged, immediately
disconnect the plug from
the wall outlet to avoid
the risk of electric shock.
Remove the battery from
the power tool: