MS 201 T
English
24
Varying cutting lengths, types of wood
and work techniques require varying
amounts of oil.
The oil flow can be adjusted as needed
using the adjusting screw (1) on the top
of the machine.
Ematic position (E), medium oil flow –
N
Turn adjusting screw to "E" (Ematic
position)
To increase oil flow –
N
turn the adjusting screw clockwise
To reduce oil flow –
N
turn the adjusting screw
counterclockwise
NOTICE
The chain must always be coated with
oil.
N
Flip the bar – after each sharpening
and each time the chain is changed
– to avoid uneven wear, especially
at the sprocket nose and on the
bottom
N
Periodically clean the oil inlet
hole (1), oil outlet channel (2) and
bar groove (3)
N
Measure groove depth – using the
measuring tool on the file gauge
(special accessory) – in the area
with the greatest wear
If the groove is not at least this deep:
N
Replace guide bar
Otherwise the drive links will grind
against the base of the groove – the
bottoms of the cutters and the tie straps
will not lie against the bar.
Oil Quantity Control
1
001
1BA034 KN
Taking Care of the Guide Bar
2
3
1
143BA026 KN
Chain type Chain pitch Minimum
groove depth
Picco
1/4“ P
4.0 mm
Rapid
1/4“
4.0 mm
Picco
3/8“ P
5.0 mm
Rapid
3/8“; 0.325“ 6.0 mm
Rapid
0.404“
7.0 mm