Stihl KM 90, Instruction Manual, Page: 14 / 74

13 KM 90, KM 90 R
English
Fitting the Throttle Cable
Do not kink the throttle cable or lay
it in tight radii – make sure the
throttle trigger moves freely.
: Press the throttle cable ( 14 ) into the
retainers ( 15 ).
Throttle Cable Adjustment
On control handles with slide:
: Go to chapter "Adjusting the
Throttle Cable".
* see "Guide to Using this Manual"
Swiveling the Handlebar
Transport position:
: Release the wing screw ( 3 ) and
unscrew it until the handlebar ( 7 )
can be turned clockwise.
: Turn the handlebar 90° and then
swing the handles down.
: Tighten down the wing screw firmly.
Working position:
: Reverse the sequence described
above to swing the handles up
and turn the handlebar counter-
clockwise.
A properly adjusted throttle cable is
the precondition for correct
operation in the full throttle, starting
throttle and idle positions.
Adjust the throttle cable only after
the unit is fully assembled – the
control handle must be in the normal
operating position.
: Use a suitable tool to push the slide
to the bottom of the slot (see
illustration).
15
14
15
14
15
250BA002 KN
Adjusting the Throttle Cable
002BA163 KN