0458-714-8621-A
18
English
10 Before Starting Work
10.1 Preparing the Hedge Trimmer for Operation
Before starting work:
► Fully charge the battery,
► Check the controls for proper function and condition,
15.1.
► Check the cutting attachment for damage or other
problems.
11.1 Setting up the Charger
WARNING
Read and follow the battery and charger safety precautions
and instructions in this manual,
other things: Make sure the charger and its components are
dry and not damaged; operate the charger indoors at an
appropriate ambient temperature,
WARNING
Since the battery and charger heat up during the charging
process, do not operate on a combustible surface or in a
location where combustible gases, liquids, vapors, dusts or
other materials and substances are present,
To set up the charger:
► Insert the plug (4) into a properly installed wall outlet (5)
matching the voltage and electrical frequency stated on
the charger's rating plate (1).
The charger runs a self-test immediately after it is plugged
in. The charger LED (2) will glow green for about
1 second, then it will glow red briefly before going out.
Once the self-test is complete, the charger is ready to
charge the battery.
► Position the power supply cord (3) so that it will not be
stepped on, tripped over, come in contact with sharp
objects or moving parts or otherwise be subjected to
damage or stress.
11.2 Charging
WARNING
Never charge a malfunctioning, damaged, cracked, leaking
or deformed battery. For indoor use only. Keep the charger
dry. Protect it from rain, water, liquids and damp conditions.
Never insert a wet battery or use a wet charger,
10 Before Starting Work
11 Charging the Battery
4
3
2
2
0000-GXX-0636-A0
5
1