FT 250
English
28
Removing the Fan Housing
N
Take out the screws (1).
N
Remove the fan housing.
Replacing the Starter Rope
N
Remove the spring clip (2).
N
Carefully remove the rope rotor with
washer (3) and pawl (4).
WARNING
The rewind spring may pop out and
uncoil during this operation – take care
to avoid the risk of injury.
N
Pry the cap (5) out of the grip.
N
Remove the remaining rope from
the rotor and starter grip.
N
Tie a simple overhand knot in the
new rope and then thread it through
the top of the grip and the rope
bushing (6).
N
Refit the cap in the grip.
N
Thread the rope through the rotor
and secure it with a simple
overhand knot.
N
Coat the rope rotor bearing bore
with non-resinous oil.
N
Slip the rotor over the starter post –
turn it back and forth to engage the
anchor loop of the rewind spring.
N
Fit the pawl (4).
N
Fit the washer (3).
N
Push the spring clip (2) into position
– it must point counterclockwise as
shown and engage the pawl's peg.
Replacing the Starter Rope
and Rewind Spring
1
1
1
1
256BA075 KN
3
2
4
256BA032 KN
6
5
256BA033 KN
256BA034 KN
3
2
4
256BA032 KN
Summary of Contents for FT 250
Page 1: ... STIHL FT 250 Instruction Manual ...
Page 2: ......
Page 39: ......
Page 40: ...www stihl com 04582620121B 0458 262 0121 B 0458 262 0121 B englisch G ...