1
002BA385 KN
► Fit the thrust plate
► Turn the mowing head anticlockwise on the
shaft (1) as far as it will go
► Retain the shaft
► Tighten the mowing head
NOTICE
Remove the tool that was used to block the
shaft.
8.4
Removing the Mowing Head
► Retain the shaft
► Turn the mowing head clockwise
9
Starting / Stopping the
Engine
9.1
Starting the Engine
Always follow the starting procedure described in
the MultiEngine instruction manual.
469BA061 AS
469BA062 AS
► Secure the handlebar in the normal operating
position.
► Retract the wheels, if fitted – see chapter on
"Wheels" in MultiEngine instruction manual.
► Retract the spur, if fitted.
► Check that the MultiTool is not touching the
ground or any other obstacles. The unit must
rest on the engine flange and the support on
the frame.
► Make sure you have good balance and secure
footing – as shown in the illustration.
WARNING
To reduce the risk of injury from contact with the
rotating attachment, always stand to the side of
the power tool, never in front of the attachment.
► With your left hand on the loop handle, press
the unit firmly against the ground – do not
touch the throttle trigger or lockout lever.
NOTICE
Do not stand or kneel on the handlebar or frame.
WARNING
The attachment may begin to move as soon as
the engine starts. For this reason, blip the throttle
after starting – the engine returns to idling speed.
Now follow the starting procedure described in
the MultiEngine instruction manual.
English
9 Starting / Stopping the Engine
10
0458-480-0121-B
