•
Take out the screw.
- Pull off the control handle.
•
Unscrew the nuts (1).
•
Remove lower clamp (2),
support block (3), bike handle (4)
and upper clamp (5) with screws
(6).
•
Use jaws (1) 5910 893 2700 to
clamp bike handle tube in vice.
- To replace left grip, carefully cut
it open and pull it off.
- Coat inside of new grip with a
little lubricant (e.g. washing-up
liquid).
Note: If too much lubricant is
used, the grip will twist on the
tube. Always leave it to dry for a
while after fitting.
•
Push the grip into position so
that the longer ends (see arrows)
point toward the gearhead at an
angle of 7 - 15 degrees to the
shaft.
Assemble all parts in the reverse
sequence.
Loop handle without barrier bar
•
Unscrew the nuts (1).
•
Remove lower clamp (2).
•
Remove screws (1).
•
Remove the loop handle (2) and
upper clamp (3).
Reassemble in the reverse
sequence.
•
Align the loop handle at
distance "A" = 20 cm from the
control handle and tighten down
firmly.
38
FS 25-4, 65-4