•
Slacken off the housing screws.
Remove the three screws
.
Lift the starter cover
off
the engine
(if vac attachment is fitted, remove
handle before starter cover)
Take out the screw
.
•
Remove the rope rotor very
carefully - the rewind spring is
seated in the rope rotor
and may pop out, uncoil and
cause injury if care is not taken.
Release spring tension by pulling
starter handle out serval inches.
Hold pulley to prevent rebound.
Pull rope. Slowly release spring
tension by allowing pulley to unwind
until all tension is gone.
•
Use a screwdriver to ease the cap
out of the starter grip.
•
Remove remaining rope from the
rotor and grip, making sure the
ElastoStart sleeve is not pushed
out of the grip.
•
Tie a simple overhand knot in the
end of the new starter rope and
then thread rope through the top of
the grip and the rope bush
.
•
Refit the cap in the grip.
5HSODFLQJWKH6WDUWHU5RSH
DQG5HZLQG6SULQJ
R
1
2
3
326BA029 KN
326BA026 KN
4
326BA027 KN
5
%*
