24
Series 4141 Powerhead
– Set air gap between flywheel and
ignition module - see 6.2.2.
– Connect the fuel hoses.
– Install the air filter - see 9.1.
– Fit throttle cable und connectors
on control handle - see 8.2.
– Fit the shroud - see 5.1.
Exercise extreme caution when
carrying out maintenance and repair
work on the ignition system.
The high voltages which occur can
cause serious or even fatal
accidents!
Troubleshooting on the ignition
system should always begin at the
spark plug. See "Standard Repairs,
Troubleshooting" handbook.
Note:
The electronic (breakerless) ignition
system basically consists of the
ignition module (1) and flywheel (2).
VA
380RA055
2
1
– Remove the shroud - see 5.1.
Use suitable pliers to grip the
spring and pull it out of the spark
plug boot.
– Unhook the leg spring from the
ignition lead.
VA
380RA076
– Slip the spark plug boot off the
ignition lead.
– Push back insulating tube and
coat end of the ignition lead
(about 20 mm/3/4") with oil.
– Fit spark plug boot over the
ignition lead.
– Use suitable pliers to grip the end
of the ignition lead inside the
spark plug boot and pull it out.
Pinch the hook of the spring into
the center of the lead, about
5 mm (3/16") from the end of the
lead.
VA
380RA077
6
Ignition System
6.1
Spark Plug Boot
Summary of Contents for 4141 Series
Page 1: ......
Page 43: ...42 Series 4141 Powerhead ...