Stihl 4137 Series, Manual, Page: 27 / 58

26 Series 4137 Components - HT
:
Pull the slide control out of the
handle molding.
VA
936RA148
:
Carefully remove the push nut
from the pivot.
VA
936RA143
:
Remove the torsion spring.
Install in the reverse sequence.
VA
936RA144
– Remove the shroud,
b
5.1
:
Disconnect the throttle cable
nipple (1) from the slotted pin (2)
on the carburetor’s throttle lever.
VA
936RA150
2
1
:
Pull the throttle cable out of the
tensioner.
VA
936RA151
:
Pull the short circuit and ground
wires (arrows) off the tags on the
ignition module.
VA
936RA152
– Remove the throttle trigger,
b
8.1.1
– Pull the short circuit wires off the
connector tags in the control
handle,
b
8.1.2
Install in the reverse sequence.
:
Make sure the short circuit wires,
throttle cable and tube are
properly positioned in the inner
handle molding.
Install all other parts in the reverse
sequence.
VA
936RA154
8.1.3 Throttle Cable