Stiga TRE 352, Workshop Manual

Page: 43 / 51

Release 00 - 03/2018
Engine TRE 352
page 43
Service manual
12 - When refitting the camshaft, maximum care
must be taken to match up the two references (19)
and (20) punched on the gears, so as to ensure
correct distribution phasing.
13 - During assembly, refer to the operations
in section [ 11.2] always remembering to re-
place the washer (6) between the sump and the
housing.
11.4. Dismantling and checking the piston, piston
rings, connecting rod and engine shaft
NOTA - These paragraphs describe all the
operations for checking and overhauling the
thermal components of the engine; it is left
to the operator to assess the advisability of
performing all the operations described or
only part of them, depending on the type of
engine problems encountered.
1 - Remove the engine from the machine [ 11.1] .
2 - Remove the cowl [ 9.2] .
3 - Remove the fan and the flywheel [ 10.5] .
4 - Dismount the cylinder head [ 10.3] .
5 - Open the cover [ 11.2] .
6 - Remove the camshaft [ 11.3] .
7 - Remove the counterbalance shaft (21).
8- Remove the cap (22) of the connecting rod (23)
by removing the two screws (24).
9 - Push the connecting rod (23) so as to cause the
piston (25) to come out of the cylinder (26).
11. ENGINE BLOCK - Overhauling internal parts
20
21
19
24
22
23
25
26
INDEX
<< BACK >>