17.
Attach other end of linkages #4 to OUTSIDE of U-support #7 with bolts
#14 and plastic washers #24. Then slide name panel #5 onto the
same bolts #14 on the
INSIDE
of U-support #7. Secure with lock nuts
#15 See
Figure 6B
. Tighten hardware until snug but do not
overtighten. Tubes must pivot freely.
18.
Attach bottom of name panel #5 to U-supports #7. Secure with
hex bolts #9 and locknuts #15. Tighten nuts but be careful not
to crush tubes. See
Figure 6B
.
19.
Attach bottom board #18 to name panels #5,
as shown in
Figure 6B
, using four bolts #32
and four hex nuts #15.
20.
Prepare an area for the assembly of the second table top half. If necessary, move the first
table top half aside with the aid of a helper. Be sure to place it in a location where it
won't be disturbed or damaged. If setting on its side, be sure to place the bottom edge
no less than 12 inches away form the wall. Also be sure to place carpet or pieces of the
shipping carton down to protect table top edges. If floor is not carpeted, brace table top
half with a heavy object to keep it from sliding.
18
15
32
15
24
14
9
9
4
24
15
32
5
15
7
4
