6
16. With first table half (that you just attached) braced against a
wall, attach second table half.
Make sure the leg assembly #9 on the second table half is
open and linkages #16 are pointing toward middle of table.
See Figure 8. With one adult person on each side of the table,
lift and set table half on its legs.
While holding table half up, slide this half toward base assembly
until the hole in Upright Tube #15 is aligned with
lower middle
hole in the Mounting Bracket #6 on the bottom of table half.
See Figure 8 and Detail B. Attach Upright Tubes #15 to Mounting
Brackets #6 with Hex Bolts #22, Washers #27 and Locknuts
#26 that you placed on floor in step 13.
17. Remove bottom bolts #21 from bottom holes that attach name
panels to Upright Tubes. Attach end of Linkage #16 to
outside
of Upright Tube #15 with bolt #21 (that you just removed),
spacer #20 and Locknut #26. Note spacer #20 goes between
linkage #16 and upright tube #15. See Figure 8 and Detail
A.
Go back over assembly and tighten all nuts snug,
but do not overtighten. Joints must pivot.
AT LEAST TWO ADULTS ARE NEEDED TO COMPLETE THE
FOLLOWING STEPS!
CAUTION:
TABLE HALF WILL NOT STAND ON ITS OWN,
YOU MUST HOLD IT UP!
CAUTION:
Figure 8
