Stiga Stig 1200, Instruction Manual, Page: 32 / 204

28 EN
4. INSTALLATION
O
9. Secure the charging base (L) to the ground with the fixing screws (M).
10. Reposition the cover (C).
11. Connect the power supply connector to the charging base and then insert the power supply plug into
the electrical outlet.
12. When the robot lawn mower is not in the charging base, make sure that the indicator light on the
charging base (N) is lit with a fixed light. (see Par. 5.4).
WARNING:
The power cable, power supply unit, extension cord and all other electric cables
which do not belong to the product must remain outside the cutting area to
maintain their distance from hazardous moving parts and prevent damage to
cables which may come into contact with live parts.
NOTE: If necessary, it is possible to extend the power cable to the charging base by using the
extension cables. Use a maximum of two 5-meters extension cables (see Chap. 9 “Accessories”).
4.5.4. RESISTOR INSTALLATION FOR SMALL PERIMETERS
Requirements and obligations:
The perimeter cable used for the installation of the robot lawn mower must be at least 40 m. long. If the
cable length is shorter, it is necessary to connect in series the resistor (see Chap. 9 “Accessories”) with the
perimeter cable.
Procedure:
After having positioned and secured the charging base correctly (see par. 4.5.3), proceed as follows:
1. Remove the cover (C).
2. Cut the ends of the cables to the exact length.
3. Apply the self-drilling connectors on the cable (F), (G), (H). (See par. 4.5.3).
4. Connect the resistor (O) to the terminal (I) of the charging base.
5. Connect the respective perimeter cable to the resistor (O).
6. Connect the other perimeter cable directly to the other terminal of the charging base.
M N C
L