Stiga ST 4262 PB, Instruction Manual

Page: 21 / 402

EN - 5
3.3 IDENTIFICATION LABEL
The identification label holds
the following data (fig. 1 ):
1. Manufacturer's address
2. Type of machine
3. Sound power level
4. CE conformity marking
5. Engine operating revolutions
6. Engine power
7. Engine displacement
8. Month / Year of manufacture
9. Serial number
10. Article code
Write the identification data of the
machine in the specific space on the
label on the back of the cover page.
IMPORTANT Use the identification names
on the identification label of the product.
IMPORTANT Use these means of
identification whenever you contact
an authorised service workshop.
IMPORTANT The example of the
Declaration of Conformity is provided
on the last pages of the manual.
3.4 MAIN COMPONENTS
The machine is made up of the
following main components (fig. 1 ):
A. Chassis
B. Dashboard
C. Engine
D. Fuel tank
E. Electric starter plug
F. Handle for manual start
G. Deflector
H. Exhaust chute
I. Paddle
J. Auger safety guard
K. Auger
L. Levelling skids
M. Lights (optional)
N. Wheel
O. Auger extension (optional)
4. ASSEMBLY
For storage and transport purposes, some
components of the machine are not installed
in the factory and have to be assembled after
unpacking. Follow the instructions below.
Unpacking and completing the assembly
should be done on a flat and stable surface,
with enough space for machine handling
and its packaging, always making use of
suitable equipment. Do not use the machine
until all the indications provided in the
"ASSEMBLY" section have been carried out.
IMPORTANT The machine is
supplied without engine oil or fuel.
4.1 ASSEMBLY COMPONENTS
The packaging holds the components needed
for assembly (fig. 3 ) listed in the following table:
ST 526 S
Pos. Description Q.ty
A Gear control 1
B Gear control fasteners -
C Spacers with screws for
securing the handle in place
2
D Gear and deflector adjustment lever grip 2
E Discharge chute adjustment cable 1
F Funnel 1
G Safety key 1
H Exhaust chute 1
I Discharge chute sliding ring 1
J M8 x 20 screws and spring washers 6
K Chute skids 3
ST 627 S
Pos. Description Q.ty
A Gear control 1
B Gear control fasteners -
C Spacers with screws for
securing the handle in place
2
D Gear-shift lever handle 1
E Funnel 1
F Safety key 1
G Exhaust chute 1
H Discharge chute sliding ring 1
I M8 x 20 screws and spring washers 6
J Chute skids 3
K Auger extension 1
L Auger extension fastening
nuts and bolts
4
4.1.1 Unpacking
1. Cautiously open the packaging, paying
attention not to lose components.
2. Consult the documentation in the
box, including these instructions.