Stiga 8211-0007-70 Instructions For Use Manual Download Page 10

61

ENGLISH

EN

2.4.18 Seat (1:T)

The seat can be folded and adjusted front-

rear. The seat can be adjusted as follows:
1. Move the control lever (1:S) upwards.
2. Set the seat to the desired position.
3. Release the control lever (1:S) to lock 

the seat.

The seat is equipped with a safety switch that is 

connected to the machine’s safety system. This 

means that certain dangerous activities are not pos-

sible when there is nobody sitting on the seat. Also 

see 4.5.2.

2.4.19 Engine casing (8:U)

In order to access the fuel cock, battery 

and engine, the machine has an engine 

casing that can be opened. The engine cas-

ing is locked with a rubber strap.

The engine casing is opened as follows:
1. Undo the rubber strap (8:V) at the front edge of 

the casing.

2. Carefully lift the engine casing back.
Close in the reverse order.

The machine may not be operated un-

less the engine casing is closed and 

locked. Risk of burns and crushing in-

juries.

3 AREAS OF USE

The machine may only be used for the following 

tasks using the genuine STIGA accessories stated.

The maximum vertical load on the towing hitch 

must not exceed 100 N.
The maximum over-run load on the towing hitch 

from towed accessories must not exceed 500 N.
NOTE! Before using a trailer – contact your insur-

ance company.
NOTE! This machine is not intended to be driven 

on public roads.

4 STARTING AND OPERATION

The machine may not be operated un-

less the engine casing is closed and 

locked. Risk of burns and crushing in-

juries.

4.1 Refuelling

Only use diesel which satisfies the minimum re-

quirements of the following specifications:

EN 590
BS 2869 A1 / A2
ASTM D 975 - 1D / 2D

The engine must not be run on rape die-
sel (RME). Contact the engine supplier 
for additional information.

1. Open the engine casing.
2. Open the fuel cap (9:X).

Filling fuel above the “Max” level in fig. 

9 results in fuel leakage and risk of fire.

3. Fill with diesel to the “Max” level in fig. 9. If 

filled above this level the fuel will leak out be-

cause it expands when heated.

4. Close the fuel cap.
Use winter fuel or add kerosene in ambient tem-

peratures below 0°C. See the table below:

Diesel is highly flammable. Always 
store fuel in containers that are made 
especially for this purpose. 

Work

Accessories, STIGA genuine

Mowing

Using mowing decks: 121 M, 

121 M El, 125 Combi Pro, 125 

Combi Pro El and with flail 

mower.

Sweeping

Using brush unit or collector 

brush unit. The use of a dust 

guard is recommended with the 

first option.

Snow clearance

Using snow blade or snow 

thrower Snow chains are recom-

mended.

Grass clipping and 

leaf collection

Using towed collector 30" or 

42".

Grass and leaf 

transport

Using dump cart Standard, Maxi 

or Combi.

Sand spreading

Using sand spreader. Can also 

be used for spreading salt. Snow 

chains are recommended.

Weeding on gravel 

paths

Using front-mounted hoe.

Lawn edge trim-

ming

Using edge trimmer.

Moss scarification Using moss scarifier.

Lowest ambi-

ent tempera-

ture at start °C

Proportion of kerosene

Summer fuel

Winter fuel

0 to -10

20%

-

-10 to -15

30%

-

-15 to -20

50%

20%

-20 to -30

-

50%

Summary of Contents for 8211-0007-70


















Reviews: