WORKSHOP MANUAL
PARK
Chapter
EDITION
2020
PAGE
40 /
124
3.2.3 Replacement of the articulated joint bearings
1. Separate the front part from the rear part and
stabilize the rear of the machine
[
2. Working from the top of the frame, eject the
lower bearing (1) together with the spacer (2).
3. Working from the bottom of the frame, eject
the upper bearing (3).
IMPORTANT
Replacement must always include
both bearings.
IMPORTANT
The bearings are of the oscillating type and therefore the assembly must be car-
ried out with the help of a nylon pad, capable of exerting the thrust only on the outer ring of each
bearing.
3.2.4 Replacement of the lifting device
NOTE
This device allows the work equipment to be kept raised and acts when the lifting pedal
is pressed and released: with a first pressure on the pedal, the equipment is raised and when
released it remains in position. With a subsequent pressure on the pedal, the mechanism is re-
leased and the equipment is lowered accompanied by the release of the pedal. This locking and
unlocking function is implemented inside the device.
1. Remove the casings of the steering column.
[
2. Remove the steering column holder.
[
from 1 to 5
3. Unscrew the screw (1) and remove the lifting
device (2).
NOTE
The lifting device is available as a spare
part as an assembled element.
When assembling, perform the steps described above in reverse order, taking care to lubricate
the device with a thin film lubricant, such as a silicone spray, WD40 or similar. DO NOT use grease.
3
2
1
1
2
