oPeraTion
seTTinGs
En
gl
ish
WWW.sTiebeL-eLTron.com
WPL 33 HT |
5
The heat pump automatically reverts to heating mode at the end
of the defrost cycle.
4. settings
The appliance is controlled by the heat pump manager WPM 2.1
and does not required any special operator actions.
f
f
Observe the heat pump manager operating and installation
instructions.
5. maintenance and care
!
Damage to the appliance and the environment
Maintenance work, such as checking the electrical safety,
must only be carried out by a qualified contractor.
A damp cloth is sufficient for cleaning all plastic and sheet steel
parts. Never use abrasive or corrosive cleaning agents.
Check the condensate drain monthly (visual inspection). Remove
contaminants and blockages immediately.
!
Damage to the appliance and the environment
Keep the air discharge and intake apertures free from
snow and leaves.
We recommend an annual inspection (to establish the current con-
dition of the system), and maintenance by a qualified contractor if
required (to return the system to its original condition).
6. troubleshooting
fault
cause
f
remedy
There is no hot water or
the heating system stays
cold.
One or more fuses/MCBs
are faulty.
Check the fuse/MCBs in
your fuse box/distribu-
tion panel.
Water collects below the
appliance.
The condensate drain
may be blocked.
Call a qualified contrac-
tor to have the conden-
sate drain cleaned out.
6.1 Other problems
If you cannot remedy the fault, notify your qualified contractor.
To facilitate and speed up your enquiry, please provide the serial
number from the type plate. The type plate is located on the front
at the top on the right or left hand side of the casing.
sample type plate
Montageanweisung beachten! Dichtheit geprüft!
Made in Germany
*xxxxxxxxxxxxxxxxxx
*
26
�0
3�
01
�1
56
4
1
1 Number on the type plate
