QUICK GUIDE
Installing the mains power cable on the HTE | HTT
314781-37971-8974
| 3
INSTALLATION
1. General information
1.1 Relevant documents
Operating and installation instructions
HTE hand dryer, part number 165505
Operating and installation instructions
HTT hand dryer, part number 171465
2. Appliance description
2.1 Standard delivery
The following are delivered with the product:
-
Power cable
-
Cable gland
-
Discharge resistor
3. Installing the power cable
WARNING Electrocution
Ensure that the appliance is isolated from the mains
power supply during installation.
Note
In the event of damage to the power cable or dis-
charge resistor, these must be replaced by a qualified
contractor using our original spare parts.
3.1 Removing the casing cover
f
f
Observe the information in the operating and installation
instructions for the hand dryer (see chapter "Installation").
3.2 Detaching the terminal strip
D
00000
43
72
4
1
4
2
3
1 Fixing screw
2 Terminal strip
3 Fan motor
4 Cable entry
The cable entry is covered by the internal wiring.
f
f
Uncover the cable entry by detaching the terminal strip:
f
f
Undo and remove the mounting screw on the terminal
strip.
D
00000
43
72
5
f
f
Pivot the detached terminal strip downward.
The cable entry is now clear.
3.3 Installing the cable gland
D
00000
43
72
6
f
f
Push the cable gland into the cable entry from inside the
appliance.
f
f
Ensure the cable gland clicks into place inside the cable
entry.
Note
A 220 mm length of power cable is required inside
the appliance.
D
00000
43
72
7
f
f
Route the power cable through the cable gland from the
back of the appliance.
