EN
GL
ISH
www.stiebel-eltron.com
DHB-E electronic |
9
Installation
Assembly
Installing the flow limite
26
�0
2�
02
�0
85
7
f
f
Position the flow limiter provided in the cold water inlet of
the appliance.
The cable grommet pointing towards the wall may hinder the
mounting of the appliance close to the wall. To prevent such prob-
lems, it is advisable to briefly press the cable grommet from be-
hind into the back panel, to reduce the stiffness of the grommet.
Mounting the appliance
26
�0
2�
02
�0
81
1
f
f
Remove the fixing toggle from the upper part of the back
panel (diagram "Mounting the appliance").
f
f
Insert the power cable from the back through the cable
grommet, until the external cable insulation is surrounded
by the cable grommet. Align the power cable. If the cross-
section of the power cable is greater than 6 mm², enlarge the
hole in the cable grommet (see also "Power supply for larger
cross-sections").
f
f
Push the appliance over the stud of the mounting bracket, so
that it breaks through the soft seal. If necessary pierce the
soft seal with a screwdriver.
f
f
Push the fixing toggle onto the stud of the mounting bracket
that penetrates the back panel.
f
f
Press the back panel firmly into place and lock the fixing tog-
gle by turning it through 90°.
Water connection
26
�0
2�
02
�0
85
8
Power connection
26
�02
�02
�1
12
2
f
f
Connect the power cable to the mains terminal (see chapter
"Wiring diagram").
Earth connection
Ensure that the appliance is connected to earth.
Installing and securing lower part of back panel
26
�02
�02
�1
102
f
f
Align the mounted appliance by loosening the fixing toggle,
aligning the power supply and back panel, and then retight-
ening the fixing toggle. If the back panel of the appliance is
not flush against the wall, the appliance can be fixed with a
screw in the lower part.