iNSTALLATiON
Appliance description
EN
GL
ISH
www.stiebel-eltron.com
SBB 302 WP (AU) | SBB 401-501 WP SOL (AU) |
5
7. Appliance description
7.1 Standard delivery
Delivered with the appliance:
- Cold water inlet pipe with flat gasket
- Adhesive rosettes for connecting lines
- Adjustable feet
- Fixing straps with closure element
- Thermometer (in its delivered condition located in the DHW
outlet)
7.2 Accessories
If it is not possible to fit an anode rod from above, install a seg-
mented signal anode.
Flanged immersion heaters and electric booster heaters are avail-
able as accessories.
Only the following accessories should be used:
- Flanged immersion heater: FCR 21/60 (part number 071330)
- Electric booster heater: BGC/45 (part number 075115)
- Corrugated connection pipe with union nut and threaded end
for optional linking of the lower and upper indirect coils:
WRV 32 (part number 232628)
SBB WP (AU) | SBB WP SOL (AU) must only be connected to spec-
ified heat pumps and solar pump assemblies. (see chapter “Spec-
ification / Heat sources”.
8. Preparations
8.1 Installation site
Always install the appliance in a room free from the risk of frost
and near the draw-off point.
Ensure the floor offers sufficient stability (see chapter “Specifica-
tion / Data table” for weight).
26
�0
3�
20
�0
00
8
f
f
Use the adjustable feet to compensate for any unevenness in
the floor.
Minimum clearances
≥500
≥300
≥300
≥800
≥100
D
00000
61
25
1
f
f
Maintain the minimum clearances.
8.2 Transport
!
Material losses
We recommend removing the cylinder casing for trans-
portation to the installation location to prevent it from
becoming dirty or damaged.
SBB 501 WP SOL (AU)
f
f
Both side insulation sections can be removed for transporta-
tion in tight spaces. To do this, remove the cylinder casing.
26
�0
3�
20
�0
00
3
f
f
Use the fixing straps to refit the thermal insulation sections
after transportation.