— 3 —
IMPORTANT NOTICE
Information and specifications are subject to change without notice.
This product has been tested and complies with the specifications for a Class B digital device, pursuant to Part
15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and
used according to the instructions, may cause harmful interference to radio communications. However, there
is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which is found by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna
- Increase the separation between the equipment or devices
- Connect the equipment to an outlet other than the receiver’s
- Consult a dealer or an experienced radio/TV technician for assistance
Operation is subject to the following two conditions: (1) this device may not cause interference, and (2)
this device must accept any interference, including interference that may cause undesired operation of the
device. Changes or modifications not expressly approved by Safety Technology International, Inc. could void
your authority to operate this equipment. To reduce potential radio interference to other users, the antenna
type and its gain should be so chosen that the equivalent isotopically radiated power (e.i.r.p.) is not more than
that permitted for successful communication. This product meets the applicable Industry Canada technical
specifications. Le présent materiel est conforme aux specifications techniques applicables d’Industrie Canada.
FCC ID: U5X-RE324 IC: 8310A-RE324
INSTALLATION GUIDE
The REPEATER is intended to be mounted indoors or in a waterproof environment. Review
the APPLICATIONS GUIDE for suggested setups.
1. Press the cover latch to remove top cover (do not lose tamper switch spring).
2. Remove the PCB from bottom cover.
Using the keyholes on the bottom cover as a template, mark the top and bottom mounting holes. Locate the
hole at least 1 foot away from the closest obstruction above.
3. Drill 3/16” holes.
4. Insert wall anchors, screws and washers (provided) and tighten to 1/8” gap.
5. TURN OFF POWER SUPPLY. Route power supply wires from the side (recommended) or hole from the back.
a. Side installation – route wires through right wire guide and then left wire guide. Remove knockout on the
top cover.
b. Rear installation – run wires through back wire guide and then left wire guide.
6. Place bottom cover keyholes onto screws and orient device vertical.
7. Tighten screws.
8. On the PCB, insert the antennas into the outer antenna terminals marked “ANTENNA.” Tighten the antenna
terminal screws.
9. Snap PCB into bottom cover so the antennas are on the plastic stands.
10. Remove the battery tab. The red LED blinks when the batteries are installed. If LED does not blink, press
and release the tamper switch. If LED still does not blink, replace batteries.
11 .Insert 12 Volt AC or DC power supply leads into the terminals marked “AC/DC 12V.” The positive and
negative terminals have interchangeable polarity. They may be oriented /- or -/+.
12. Turn on the power supply. The green LED turns on. If the red LED is on, replace the 3 AAA Alkaline
batteries.
13. (If desired) Program the REPEATER and/or the sensors into the receiver (follow the receiver programming
instructions). The receiver can monitor the REPEATER’S supervision and trouble signals when enrolled.
To manually send a REPEATER signal, press and release the tamper switch. The red LED blinks when
transmitting.
14. If the REPEATER or the sensors do not program properly, move the REPEATER mounting location closer to the
receiver.
15. Latch the top cover in place. Ensure the power supply wires are routed properly.
