- 4 -
Install or Remove Contact Block
INSTALL
To attach, align tabs (as shown) and gently snap top then bottom. Be sure
to hear BOTH tabs snap into place. (Can be reversed if wiring comes from
the bottom of the box.)
REMOVE
Repeat STEP A for the top and bottom tab before pulling on contact block.
Step A: Position small flat screwdriver blade under tab and gently rotate until
tab disengages. The contact block will rotate a little.
DO NOT PULL YET.
Step B: Repeat for opposite tab.
Step C: When both tabs are disengaged, pull the contact block straight off.
4.880 in
[123.95 mm]
3.218 in
[81.74 mm]
.875 in
[22.23 mm]
1.625 in
[41.28 mm]
TOP TAB
A
B
#6-32 x 1 in. PHILLIPS
HEAD MACHINE SCREW
(2) PROVIDED
KIT-71100A-COLOR
BACKBOX
(OPTIONAL)
#6 x 1-1/4 in.
PHILLIPS PAN HEAD SCREW
(4) PROVIDED w/ KIT-71100A-COLOR
#8-32 x 3/8 in. SCREW
DRILL POINT PROVIDED TOP & BOTTOM
FOR 1/2 in. CONDUIT. DRILL AS NEEDED
#8-10 7/8 in. ANCHOR
(4) PROVIDED w/ KIT-71100A-COLOR
DRILL (4) 3/16 in. DIAMETER HOLES
DRILL OUT THE (4) MOUNTING
HOLES, ONE IN EACH CORNER,
USING 5/32 in. DRILL BIT
BACKBOX MUST BE MOUNTED
WITH ARROWS POINTING UP
1.625 in.
(41.28mm)
1.575 in.
(40.01mm)
#6-32 x 1 in. PHILLIPS
HEAD MACHINE SCREW
(2) PROVIDED
#8-32 x 3/8 in. SCREW
STEP A COMPLETED
TOP TAB
NC
NO
COM
LED
TERMINALS
STEP A
STEP B
STEP C