STI 34108 Installation And Operation Manual Download Page 8

Inst. Sht. 8-Channel Wireless DEC2012

WARNINGS

FOR INDOOR USE ONLY.  Keep RECEIVER away from water and/or damp areas. 

WARRANTY INFORMATION

Safety Technology International, Inc. warrants to the 

original 

consumer/purchaser that this product shall be free of defects in 

material and workmanship under normal use and circumstances for a period of one (1) year from the original date of purchase.
Electronic warranty form at www.sti-usa.com/wc14.

IMPORTANT NOTICE

This product has been tested and complies with the specifications for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits 
are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can 
radiate radio frequency energy and, if not installed and used according to the instructions, may cause harmful interference to radio communications.  
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to 
radio or television reception, which is found by turning the equipment off and on, the user is encouraged to try to correct the interference by one 
or more of the following measures:    
- Reorient or relocate the receiving antenna   
- Increase the separation between the equipment or devices   
- Connect the equipment to an outlet other than the receiver’s   
- Consult a dealer or an experienced radio/TV technician for assistance
Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, 
including interference that may cause undesired operation of the device. 
Changes or modifications not expressly approved by Safety Technology International, Inc. could void your authority to operate this equipment.
To reduce potential radio interference to other users, the antenna type and its gain should be so chosen that the equivalent isotropically radiated 
power (e.i.r.p.) is not more than that permitted for successful communication. 
This product meets the applicable Industry Canada technical specifications.
Le present materiel est conform aux specifications techniques applicables d’Industrie Canada.
Model: 34108          FCC ID: TXL34108    IC: 6335A-34108
This device is a wireless receiver intended for home and office use in all EU and EFTA member states.

ADDITIONAL WIRELESS ALERT SERIES PRODUCTS

STI-34098  Single Channel Slave Receiver
STI-V34104  4-Channel Voice Receiver
STI-34108   8-Channel Receiver
STI-34188  8-Zone Relay Board
STI-34101  Solar Powered Driveway Monitor Sensor
STI-34151  Battery Powered Driveway Monitor Sensor
STI-34201  Wireless Mail Alert Sensor
STI-34301  Wireless Garage Sentry Sensor
STI-34401  Wireless Universal Alert Sensor
STI-34501  Wireless Door Entry Alert

®

 Sensor

STI-34601  Wireless Doorbell Button
STI-34701  Indoor Wireless PIR
STI-34752  Outdoor Wireless PIR

STI-6200WIR  Wireless Fire Extinguisher Theft Stopper
STI-6200WIR4  Wireless Fire Extinguisher Theft Stopper w/Receiver
STI-6400WIR  Wireless Exit Stopper Door Alarm
STI-6400WIR4  Wireless Exit Stopper Door Alarm with Receiver
STI-6517A 

Wireless Stopper Station Shield with Sound

STI-6517B  

Wireless Stopper Station Shield with Sound &    

 Transmitter 
STI-6517C 

Wireless Stopper Station Shield with Wireless    

 Transmitter
STI-6517D 

Wireless Stopper Station Shield with Button Sound  

 

and Transmitter

STI-30105 

Extended Antenna

STI-34105 

Voltamax 12VDC (500mA) Power Supply

STI-34106 Keyfob

2306 Airport Rd • Waterford, MI 48327, USA

Phone: 248-673-9898 • Fax: 248-673-1246

[email protected] • www.sti-usa.com

Safety Technology International Ltd

Taylor House • 34 Sherwood Road • Bromsgrove

Worcestershire • B60 3DR • England • Tel: +44 (0)1527 520 999

Fax: +44 (0)1527 501 999 • [email protected] • www.sti-emea.com

Summary of Contents for 34108









Reviews: