STG global TANVAC HDV3000, Operator'S Manual

Page: 72 / 329

6. Allow the engine to idle for 3 to 5 minutes, or allow
the engine to idle until the water temperature
indicator begins to rise. The engine should run at
low idle smoothly until speed is gradually
increased to high idle. Allow the white smoke to
disperse before proceeding with normal operation.
7. Operate the engine at low load until all systems
reach operating temperature. Check the gauges
during the warm-up period.
i02242604
Starting with Jump Start
Cables
SMCS Code: 1000; 1401; 1402; 1900
Improper jump start cable connections can cause
an explosion resulting in personal injury.
Prevent sparks near the batteries. Sparks could
cause vapors to explode. Do not allow jump start
cable ends to contact each other or the engine.
If the installation is not equipped with a backup
battery system, it may be necessary to start the
engine from an external electrical source.
First, determine the reason that it is necessary to
start with power from an external source.
Many batteries which are considered unusable are
still rechargeable. After jump starting, the alternator
may not be able to fully recharge batteries that are
severely discharged. The batteries must be charged
to the proper voltage with a battery charger. For
information on testing and charging, refer to the
Special Instruction, SEHS7633, “Battery Test
Procedure”.
NOTICE
Using a battery source with the same voltage as the
electric starting motor. Use ONLY equal voltage for
jump starting. The use of higher voltage will damage
the electrical system.
Do not reverse the battery cables. The alternator can
be damaged. Attach ground cable last and remove
first.
When using an external electrical source to start the
engine, turn the generator set control switch to the
“
OFF
”
position. Turn all electrical accessories OFF
before attaching the jump start cables.
Ensure that the main power switch is in the OFF posi-
tion before attaching the jump start cables to the en-
gine being started.
1. Turn the start switch on the stalled engine to the
OFF position. Turn off all accessories.
2. Connect one positive end of the jump start cable to
the positive cable terminal of the discharged
battery. Connect the other positive end of the jump
start cable to the positive cable terminal of the
electrical source.
3.
Connect one negative end of the jump start cable
to the negative cable terminal of the electrical
source. Connect the other negative end of the
jump start cable to the engine block or to the
chassis ground. This procedure helps to prevent
potential sparks from igniting combustible gases
that are produced by some batteries.
4. Charge the batteries. The engine will not continue
to run after starting if the batteries have not been
charged.
5. Start the engine.
6. Immediately after the stalled engine is started,
disconnect the jump start cables in reverse order.
i01646248
After Starting Engine
SMCS Code:
1000
Note: In temperatures from 0 to 60°C (32 to 140°F),
the warm-up time is approximately three minutes. In
temperatures below 0°C (32°F), additional warm-up
time may be required.
Note: Ensure that the self test for the monitoring
system (if equipped) is completed before operating
the engine under load.
When the engine idles during warm-up, observe the
following conditions:
• Check for any fluid or for any air leaks at idle rpm
and at one-half full rpm (no load on the engine)
before operating the engine under load. This is not
possible in some applications.
• Operate the engine at low idle until all systems
achieve operating temperatures. Check all gauges
during the warm-up period.
Note: Gauge readings should be observed and the
data should be recorded frequently while the engine
is operating. Comparing the data over time will help
to determine normal readings for each gauge.
Comparing data over time will also help detect
abnormal operating developments. Significant
changes in the readings should be investigated.
SEBU8312-03 35
Operation Section
Starting with Jump Start Cables