stewmac.com
52
©2019 StewMac
STEP 154
Install the fuse
Insert the 1-amp fuse into the fuse
socket and make sure the socket cap
is secure . Never use a fuse rated above
1 amp in this amplifier .
STEP 155
Install the capacitor pan
Use the self-tapping screws to mount
the capacitor pan on the chassis,
covering the filter cap board .
Installing parts and preparing for testing
STOP!
DON’T
INSTALL THE TUBES YET!
DON’T
PLUG THE AMP IN YET!
The next page is going to keep
you out of trouble!
STEP 158
Set the chassis on a chassis stand
or on blocks for testing
Set your chassis up for final testing .
Chassis stands are extremely useful
for this . If you do not have a chassis
stand a couple of blocks of wood can
work just fine .
STEP 156
Install the pilot lamp
Insert the pilot lamp bulb into its
socket from the front of the chassis
and twist until it locks back in place .
Screw the red jewel lens over the
socket .
STEP 157
Install the control knobs
Turn the shaft of each pot to “zero”
and install the knob so that the
indicator line points to number 1 .
